Kuppersbusch USA Ventilation Hood IKD 11571 GE UL User Manual

Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 1  
INSTRUCTIONS FOR USE AND  
INSTALLATION INSTRUCTIONS  
IKD 1157.1 GE-UL  
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 3  
Index  
Once the kitchen hood has been installed,  
ensure that the feed cable to the network is  
not in contact with any live metal edges.  
Page  
Description of the apparatus  
Instructions for use  
Programming timer  
Cleaning and maintenance  
Problem solving  
3
4
4
4
5
5
6
6
7
8
Avoid connecting the apparatus to  
conductors used exits for fumes produced  
by a non-electric energy source. E.g.:  
boilers, chimneys, etc.  
If the extractor fan is going to be used  
simultaneously with equipment powered by  
a non-electric energy source. E.g.: gas  
cookers, the room must have sufficient  
ventilation.  
Sizes and specifications  
Accessories supplied  
Grounding instructions  
Installation  
The lower part of the kitchen hood must be  
fitted at least 60 cm. (23,6 in) over electric  
hobs and 65 cm. (25.6 in) over gas or mixed  
hobs.  
Avoid cooking under the kitchen hood if the  
metal filters are not fitted, e.g.: while they  
are being cleaned in the dishwasher.  
Active charcoal filters  
Description of the apparatus  
We recommend the use of gloves and to be  
extremely careful when cleaning the kitchen  
hood's interior.  
A
Electronic programmer control box with  
buttons to control speed, light and  
power in use indicators.  
Your kitchen hood is designed for domestic  
use and only for extraction and purification  
of gases produced during food preparation.  
It will be your responsibility if it is used for  
other purposes, which may be dangerous.  
The manufacturer cannot accept responsi-  
bility for damage caused by improper use of  
the apparatus.  
B
C
Metal filters.  
Lamp with two lights - 20 W (G-4).  
D, E Vertically adjustable tubecovers.  
Decorative part. ( No incluided ).  
F
For repairs please contact the nearest  
KÜPPERSBUSCH Technical Assistance  
Service, and always use genuine spare  
parts. Repairs or modifications effected by  
unqualified  
personnel  
can  
cause  
malfunctions or may damage the  
apparatus, putting your safety in danger.  
3
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 4  
Instructions for use  
Cleaning and maintenance  
You may control the kitchen hood's workings  
by operating the controls as shown in the  
diagram.  
When cleaning and doing maintenance,  
make sure the safety instructions set out  
on page 2 are complied with.  
Cleaning the body of the kitchen hood  
If your kitchen hood is made from stainless  
steel, use this material's specially designed  
cleaners following the instructions  
mentioned in the product supplier´s  
instructions.  
3
2
1
Never use metallic scourers, nor abrasive  
or corrosive products.  
1
2
3
Dry the kitchen hood using a cloth that  
does not produce fluff.  
Cleaning the metal filters  
To remove the filters from their fittings, press  
lightly on the locks and then pull them off.  
To improve draught we recommend to turn  
the extractor fan on a few minutes before  
cooking so that the flow of air is continuous  
and stable when fumes are extracted.  
The metal filters can be cleaned by soaking  
them in hot water with neutral detergent until  
the fat dissolves and then rinsing them under  
the tap or using products specially designed  
for fats. They can also be washed in a  
dishwasher. In this case, it is advisable to  
stack them vertically to avoid food residue  
sticking to them.  
Similarly, keep the extractor fan on for a few  
minutes after cooking to completely extract  
fumes and odours.  
Cleaning in a dishwasher with aggressive  
detergents or polish may damage the metallic  
surface (blackening it), although this will not  
affect its fat retention capacity.  
Programming timer  
1.- By pressing for more than 2 seconds any  
speed, the kitchen hood will stay switched on  
for 10 minutes at the selected speed. To  
program a duration other than 10 minutes:  
Once clean, leave them to dry off and then fit  
them onto the kitchen hood.  
Changing lights  
a).- With the kitchen hood switched off, press  
“timer”.  
b).- Select the required programming time by  
pressing the chosen button (see drawing).  
c).- Press “timer” again to record the new  
program.  
Proceed as follows:  
Unscrew the decorative element of the  
halogen lamp.  
Change the broken/burnt out lamp.  
Maximum lamp power is 20 W (G-4).  
d).- Press the chosen speed for more than 2  
seconds, the pilot light will start flashing.  
Screw back on the decorative element of  
the halogen lamp.  
4
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 5  
Problem solving  
Proceed with the following checks before calling the Technical Service:  
Problem  
Possible cause  
Solution  
The kitchen hood feed cable is not connected to Connect feed cable to the network.  
the network.  
The extractor fan ceases to function  
There is no electrical current in the network  
Check that the network has electrical current  
Filters are saturated with fat.  
Change or clean the active charcoal and/or metal  
filters, as the case may be.  
The extractor ceases to educt strongly  
or vibrates  
Obstruction in the air exit conduct  
Eliminate the obstruction  
The lamps are burnt out  
The lamps are loose  
Change the lamps  
Tighten the lamps  
The lamps do not light up  
Sizes and specifications  
3
2
1
5
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 6  
F .Nr**********  
U
C
©
L
US  
LISTED  
ELECTRIC FAN  
XXXX  
Tec. Cod.  
Technical  
Code  
Network  
Frecuency (Hz)  
Lights/ Motor Power  
(W)  
Network Code (V)  
Motor Volume  
22UL324IS  
120  
60  
2x20 / 340  
850 m3/h  
KÜPPERSBUSCH reserves the right to make changes and corrections to its products  
as it deems necessary, without altering their basic characteristics.  
WARNING: Improper grounding can  
Accesories supplied  
result in a risk of electric shock.  
1
1
6
150/125 mm reduction.  
Anti-recoil valve.  
Consult a qualified electrician if the  
grounding instructions are not completely  
understood, or if doubt exists as to whether  
the appliance is properly grounded.  
Lock screws (Ø8 x 45).  
Do not use an extension cord. If the power  
supply cord is too short, have a qualified  
electrician install an outlet near the  
appliance.  
Grounding Instructions  
This appliance must be grounded. In the  
event of an electrical short circuit,  
grounding reduces the risk of electric  
shock by providing an escape wire for the  
electric current. This appliance is plugged  
into an outlet that is properly installed and  
grounded.  
6
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 7  
Installation with output vent  
Installation  
On installing the kitchen hood make sure  
that the Safety Instructions set out on  
page 2 are complied with.  
Fig. 1 (Pag. 8)  
1) Using the support (O), trace and drill the  
points for fitting the lock screws (S) (Ø8 x 45)  
onto the ceiling.  
2) Screw the support (O) into the ceiling with  
the lock screw (S) (Ø8 x 45).  
WARNING: TO REDUCE THE RISK OF  
FIRE, ELECTRIC SHOCK, OR INJURY  
TO  
PERSONS,  
OBSERVE  
THE  
3) Mount the top inner body (A6) in the  
support (O) with the screws (Q) (M6 x 16).  
FOLLOWING:  
a. Installation work and electrical wiring must  
be done by qualified person(s) in accordance  
with all applicable codes and standards,  
including fire-rated construction.  
4) Softly attach the decorative handle (W) to  
the decorative glass part (U) with the screws  
(X) (M5) and the washers (Y) provided with  
the glass.  
5) Adjust the decorative glass part (U), fixing  
it to the body of the kitchen hood using the  
screws (V) (M4) provided with the glass.  
b. Sufficient air is needed for proper  
combustion and exhausting of gases through  
the flue (chimney) of fuel burning equipment  
to prevent back drafting. Follow the heating  
equipment manufacturer´s guideline and  
safety standards such as those published by  
the National Fire Protection Association  
(NFPA), and the American Society for  
Heating, Refrigeration and Air Conditioning  
Engineers (ASHRAE), and the local code  
authorities.  
6) Fit the part (A) if the inner tube (not  
supplied) is Ø150 or (A) + (B) if it is Ø120.  
7) Attach the inner tube with a clamp (not  
supplied) to (A) or (B) as the case may be.  
8) Introduce the upper tubecover (A8) into the  
lower tubecover (A9).  
9) Adjust the group lower tubecover (A9) and  
upper tubecover (A8) to the bottom inner body  
(A7) and to the decorative glass wing (U).  
c. When cutting or drilling into wall or ceiling,  
do not damage electrical wiring and other  
hidden utilities.  
10) Mount the bottom group to the top, fixing  
it to the ceiling with the screws (A10) (M4 x  
12) to the desired height.  
d. Ducted fans must always be vented to the  
outdoors.  
11) Fit the top part of the inner tube (not  
supplied) to the output vent.  
WARNING: TO REDUCE THE RISK OF  
FIRE, USE ONLY METAL DUCTWORK.  
12) Lift the upper tubecover (A8) up to the  
desired height and fix it to the top group with  
the screws (G) (M4 x 12, flat head).  
WARNING: To Reduce The Risk Of Fire  
Or Electric Shock, Do Not Use This Fan  
With Any Solid-State Speed Control  
Device.  
13) Adjust finally the decorative glass part (U),  
fixing it to the body of the kitchen hood using  
the screws (V) (M4) provided with the glass.  
To obtain optimum performance, the external  
conduct must not be more than FOUR  
METRES LONG, have more than two 90°  
angles and its diameter must be at least  
Ø120.  
7
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 8  
FIG.1  
1) Using the support (O), trace and drill the  
points for fitting the lock screws (S) (Ø8 x 45)  
onto the ceiling.  
Installation witouth output vent, with  
active charcoal filters (Optional)  
2) Screw the support (O) into the ceiling with  
the tirafondos-anclaje (S) (Ø8 x 45).  
When exterior gas extraction to the outside is  
not possible, then the kitchen hood may be  
set to purify the air by recycling it through  
active charcoal filters.  
3) Mount the top inner body (A6) in the  
support (O) with the screws (Q) (M6 x 16).  
The active charcoal filters have an active life  
of between three to six months, depending on  
the individual conditions of use. These filters  
cannot be washed nor regenerated. They  
must be replaced once their useful life comes  
to an end.  
4) Softly attach the decorative handle (W) to  
the decorative glass part (U) with the screws  
(X) (M5) and the washer (Y) provided with the  
glass.  
5) Adjust the decorative glass part (U),  
carrefully fixing it to the body of the kitchen  
hood using the screws (V) (M4) provided with  
the glass.  
SET type 1 - Fig. 2 (Page 9)  
8
 
Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 9  
6) Fit the part (A) if the inner tube (not  
supplied) is Ø150 or (A) + (B) if it is Ø120.  
to the desired height.  
12) Mount the part (A5) with the screws (A4)  
(M4 x 12) in the rectangle parts of the top  
inner body (A6).  
7) Attach the inner tube with a clamp (not  
supplied) to (A) or (B) as the case may be.  
13) Lift the upper tubecover (A8) up to the  
desired height and fix it to the top group with  
the screws (G) (M4 x 12, flat head).  
8) Introduce the upper tubecover (A8) into the  
lower tubecover (A9).  
9) Adjust the group lower tubecover (A9) and  
upper tubecover (A8) to the botton inner body  
(A7) and to the decorative glass wing (U).  
14) Adjust finally the decorative glass part (U),  
fixing it to the body of the kitchen hood using  
the screws (V) (M4) provided with the glass.  
10) Fit the circular entrance of the part (A5) to  
the top part of the inner tube (not supplied)  
with a clamp (not supplied).  
15) Put the filters into the lateral draught  
section of the motor making the holes in the  
filters match up (A11) with the pivots (A12) of  
the motor carcass.  
11) Mount the bottom group to the top, fixed  
to the ceiling with the screws (A10) (M4 x 12)  
FIG.2  
9
 

La Crosse Technology Weather Radio TX62U IT User Manual
Lenovo Computer Monitor L194 User Manual
LG Electronics Indoor Fireplace ELITE CVF User Manual
Listen Technologies Carrying Case LA 334 User Manual
LST Smoke Alarm 2251CTLE User Manual
Lumiscope Thermometer L2214 User Manual
Magnavox DVD Recorder MRV640 User Manual
Magnavox VCR VRU26AT User Manual
McCulloch Chainsaw 41BY66AR077 User Manual
Melissa Patio Heater 670 202 203 User Manual