McIntosh Stud Sensor R649 User Manual

R649 External Sensor  
Installation Guide  
The R649 mounts in a standard one-gang wall out-  
let box and connections are made using a RG59U  
or RG6 Coax Cable (300ft max.) with “F” Connec-  
tors at both ends. Connect the Coax Cable between  
the R649 and the “F” Connector on a McIntosh A/  
V Control Center, Preamplifier, Multizone Control-  
ler or Integrated Amplifier. Up to four sensors can  
be connected in parallel. When the R649 is used  
with a McIntosh A/V Control Center that uses a  
Five Pin Terminal Connector, connect the Center  
Wire to Pin 4 and the Shield to Pin 5.  
Note: Before connecting the R649 to a McIntosh  
A/V Control Center, Preamplifier, Multizone  
Controller or Integrated Amplifier, make  
sure that the Main AC POWER Switch is in  
the Off Position (or remove the units AC  
Plug from the AC Wall Outlet).  
McIntosh Part No. 040802  
 

Lasko Fan H20600 User Manual
Lenovo Computer Monitor T545 User Manual
LG Electronics CRT Television DU 27FB34C User Manual
Life Fitness Home Gym 805101 User Manual
Magellan GPS Receiver 860T User Manual
Maxell DVD VCR Combo ZRY 316 User Manual
Maytag Trash Compactor MTUC7000AWS User Manual
Meade Telescope RCX400TM User Manual
Meade Telescope Telescopes User Manual
Midland Radio Two Way Radio 1001z User Manual